Home > Hp Envy > HP Envy 17 Left Hinge Issue With Something Rattling Inside

HP Envy 17 Left Hinge Issue With Something Rattling Inside


After that just have fun with the fixed “zombie” laptop. is it possible to use a hair dryer? Cant it be soldered and fixed, while i buy in good time a new one.Please suggest. Or, could it be a bad inverter? check my blog

Anyway… trying to determine how I would figure out which hinge I need without it? IML Tech December 15, 2010 | Jeremy, After HP replaced the screen, The webcam didnt work. ReplyDeleteAnonymous17 February 2016 at 11:50Pavilion g7. So if you are still using your HP/Compaq laptop and using the trick, please keep in mind that there could be a failure that might cause you to lose files/info.

Hp Envy 17 Hinge Repair

If you see a clear image of your desktop, your back light is out. The screen suddenly went blank. Tomas. If you are not sure how to check your forum messages,this post has instructions.

So it has an issue with a bad screen and it has to be replaced. I worry that is can get stuck in the fan and cause hardware issues. I had some strange lines on the screen for few months and it worked only with generic driver (hanging with nvidia drivers). Hp Envy Touchsmart 17 Hinge Repair I have a HP dv2000 that has sat in a draw now for almost a year after my local computer repair shop told me my video card was damaged and could

I took it apart and checked the connections, they are all tight. I tightened up the two right hinge screws that come up from the bottom and it is nice and tight now. A++++ It was kinda tricky to fix the RIGHT side HINGE but with further investigation it was handled. shean February 3, 2011 | hi I have a compaq preserio F700 laptop an when I turn it on it stays on for a few seconds an turrns off lights all

The top panel pops out as I open the screen and clicks back in place when I close it. Hp Envy Replacement Screws I would say the heat gun method would be preferred if you are able to disassemble the laptop and remove the motherboard. SEE STEP 4. IML Tech November 2, 2009 | Andrew, Wow what a write up.

  • Sounds like a problem with the LCD cable (harness).
  • As being said before, I would not trust this fix to run for long - month if lucky.
  • and allowed it to cool down …..
  • So thanks again for everything!

Hp Envy 15 Screws

When I took the laptop apart, pedestals on the bottom case where the hinge fastens were broken off. HP Envy 15 In this notebook the keyboard is mounted to the top cover assembly, after the assembly has been removed, you will be able to access the hard drive, internal Hp Envy 17 Hinge Repair Otherwise, I wouldn't replace the cover. Hp Envy Touchsmart 15 Screws HP Pavilion DV8000T A keyboard checkup guide.

I had the display up all last night to reinstall Windows (a different issue). click site Sounds like the video cable failure. I found this site re the bubble wrap method & said ‘what the heck' ‘cuz I was out of free options. re installed drives and battery. Hp Envy 15 Replacement Screws

I was afraid I'd burn something up. Please HELP! 0 0 Futoji Retired Posts: 3,791 Member Since: ‎03-11-2014 Message 9 of 183 (5,330 Views) Report Inappropriate Content Re: HP Envy 17 Broken Screw Fitting on Case Near Left I did as instucted and removed battery and hard drive, then taped all air vents plugged it in and bubble wrapped and also wrapped in a towel. news Try booting your laptop with Ubuntu (live Linux CD).

So HP is not at the top of my list when it comes to my next laptop. Hp Envy Bottom Screws If it's not the cable, most likely it's either bad LCD screen or motherboard (graphics card) failure. I am far from a computer genius and found this all very easy.

Cheers.DeleteReplyAnonymous5 January 2017 at 11:53Except it's putting stress on the threaded brass inserts in the plastic, which stresses the plastic.

Could be bad LCD screen. do you think i just need a new screen? Something like Fn key + one of the Fx keys. Hp Envy Hinge Fix Learn How to Post and More  Community News  Best of the Community Blog  Notebooks Notebook Operating System and Recovery  Notebook Boot and Lockup  Notebook Wireless and Networking  Notebook Audio  Notebook Video,

The white screen could indicate bad connection between the video cable and LCD screen. We service customers in every state in the country as well as several locations outside the US. NO ONE who does this with success publishes the times an temps, which are essential to do the work even if you laid down the thousands of dollars for the BGA More about the author Only one screw in front during step 9. 2 more screws underneath the hinge, in the battery compartment.

I guess laptops still work fine for them after repair. The innards appear to be fine - I can attach the external screen and Function F4 and things are great. However, (and this is the big fix) take out the little rubber spacer between the video chip and the coolant line and replace it with a clean penny, greased on both Anyway, I didn't touch it for about 30 minutes and let it cool down.

Pat December 23, 2010 | Often no video in a laptop means a bad inverter board, in most cases a new one is under $20. Stephanie July 15, 2010 | Your instructions helped me a whole lot. If you know how the GPU looks, it's hard to confuse with the CPU. Got started yesterday. 7 of 8 screw mounts in the cover were broken 3 of them completely destroyed.

I didn't really even consider doing this work myself to be a possibility before finding this page. Good on you mate. hdd like blinks afer 5 sec. Thom November 2, 2009 | Thanks for the writeup.

Koala October 12, 2011 | So to everyone who has owned a HP/Compaq with these problems listen up: Short version of my story….Own a DV6000 HP laptop. It really looks like a simple task but I'd really rather just not fix it at all if it's not going to effect my laptops performance, and/or mess up any connections I felt like this was the end, but started doing research on the problem and possible solutions. I don't know.

It's the part number to a single lamp display w/o microphone or webcam. IML Tech July 15, 2010 | BigD, I have a problem with my Pavilion Dv9610us laptop. However, dont worry, the processor can handle the heat. Here is what I did: I wrapped the laptop excluding the monitor side after turning it on(of course without HDD and battery).

I found a larger screw with a larger head and got the corner secure. After you remove the LCD screen, it's very easy to replace the display cover. I bought the hinges left and right dv9000 on EBAY.